Oswan wonder swan link cable how to#

I then solder the resistor wire to pin 1 on the cart connector. Solder your resistor in between 2 wires, if using. It should all not lie flush.ĭrop your screen back in. When you've removed the plastic, reapply the reflective sheet to the screen backlight combo. Remove the white reflective sheet from the back of the backlight, and then gently remove the plastic case.

Note, the screen won't fit properl y yet. Don't worry too much about getting it perfectly straight. Now take your wonderswan screen, and line it up with the backlight, the wide side of the screen should match with the wide side of the backlight. Take the screen itself off of the backlight. Now we're going to attach the screen to the backlight. Put it somewhere safe, and away from dust. It's a right pain in the arse though, so it's best just to not touch it) (If you did accidentally tough it, you can remove the glue with acetone, or isopropyl alcohol. The under layer is coated with glue, and if you touch it, you'll be stuck with a finger print. The trick is to start peeling it with a craft knife, then once you have enough to grab, slowly pull it off. Remove the reflective backing from the screen. If you kind of twist the shell a bit, you should hear a crack, and the screen will come loose. The screen is attached to the console by a small piece of adhesive, and can be easily removed, but make sure NOT to pull the ribbon cable. Once the console is open, remove the screen by opening the catch at the top, and slowly removing the ribbon cable. You'll need to remove the 6 screws with a Torx 7 screwdriver. be careful, you don't want to damage the backlight. For my screen that involves sliding a blade under the screen to cut throught the sticky foam, and then cutting the ribbon cable around the backlight pads. Be aware without a resistor, the backlight will be incredibly bright.

I use 140R, you can use whatever you want, or none at all. the important part is that it needs to run on 3.3v!)Ī resistor. Please note, my final product has a black mark on it because I was rushing to get this done, but if you take your time, you won't have such a problemĪn original wonderswan (this will NOT work on a colour or crystal)Ī backlit LCD screen (I buy mine on aliexpress.

Oswan wonder swan link cable how to#

Keep in mind that each flash cartridge can contain only one game, and every time you want to change the game you need to reflash it on the cartridge.įor the ROM loading, dumping your own games won't work unless you patch the rom file to modify their save type to match the ones in the Flash cartridge.Hey everyone! A few people have been asking me how to backlight a wonderswan, so, finally, a tutorial for you. So to sum up, unless you want to play those two specific games or program/load wonderwitch games, it's a way better choice to buy the V1 (for the price of the RTC V3 you can get 2 or 3 V1). As far as I know the only two games that need it are the 2 winners of the wonderwitch programming contest, that got release on special cartridges, Judgement Silversword and Dicing Knight. The V3 with RTC/2048kbit SRAM/64mbit Flash, the most expensive one, which is useful only for the games that require RTC, and/or need bigger save space and storage. The V3 with 2048kbit SRAM/4mbit Flash, more expensive, it is a clone of the wonderwitch cartridge, useful only if you want to program your own game or play wonderwitch user made games. The V1 with 256kbit SRAM/64mbit Flash, it's the cheapest one and the one you would want for normal games.

The only solution I found is buying a Cartridge dumper and buying the wonderdog cartridges, which is a lot more expensive than a all in one flashcart, but allows you to dump your own games/saves. Yeah that's so sad Flash Masta aren't producing those anymore, they looked like great cartridge.